<div dir="ltr">Hi Team,<div><br></div><div>I want to create one SR tunnel between 4 FRR nodes where one node will be used as head-end node which will be used to push the label stack.SRGB in all these nodes will be same(10000-19999).I am going to use the loopback interface for node SID. I have few questions in this regard:</div><div>(1) How can I use one dummy interface as loopback in case of SR,I have tried using a dummy interface previously for vanilla OSPF and BGP,it works fine but in case of SR config,it complains:</div><div>not a loopback interface</div><div>(2)To provision the tunnel effectively,how can I use prefix SID for the connected interfaces.</div><div>I was using:</div><div>ip route x.x.x.x/mask <gateway> label as the node SID </div><div>Here,how can I configure prefix SID for the prefixes other than the node prefix.</div><div>(3)How can I verify the tunnel in the data plane (e.g. ping works fine).</div><div><br></div><div>Any sample config in this regard will be helpful.</div><div><br></div><div>Thanks,</div><div>Shuvro</div></div>