<div dir="ltr"><div dir="ltr"><div dir="ltr">Hi Team,<div><br></div><div>Want to know if SR TE is supported in the latest stable release of FRR.</div><div><br></div><div>I can see few TE related CLIs like : mpls-te on under router ospf and other segment routing commands but not able to see the TE parameters being used.</div><div><br></div><div>My config for device1 looked like below:</div><div><div>router ospf</div><div> ospf router-id 1.1.1.1</div><div> network <a href="http://1.1.1.1/32">1.1.1.1/32</a> area 0</div><div> network <a href="http://20.1.1.0/24">20.1.1.0/24</a> area 0</div><div> capability opaque</div><div> mpls-te on</div><div> mpls-te router-address 1.1.1.1</div><div> segment-routing on</div><div> segment-routing global-block 10000 19999</div><div> segment-routing node-msd 8</div><div> segment-routing prefix <a href="http://1.1.1.1/32">1.1.1.1/32</a> index 1100 no-php-flag</div><div> router-info area</div></div><div><br></div><div>I have installed required mpls kernel modules in the box but if I go and check mpls-te interface ,I see below:</div><div><div>show ip ospf mpls-te interface </div><div>  eth0: MPLS-TE is disabled on this interface</div><div>  eth1: MPLS-TE is disabled on this interface</div><div>  eth2: MPLS-TE is disabled on this interface</div><div>  eth3: MPLS-TE is disabled on this interface</div><div>  lo: MPLS-TE is disabled on this interface</div></div><div><br></div><div>Can anyone throw some light on how to make use of the TE parameters.</div><div><br></div><div>Thanks,</div><div>Shuvro</div></div></div></div>