I was in the process of migrating a few quagga sites to frr and noticed that the default build suggests enabling fpm on frr. As far as I can tell, fpm is disabled on quagga. If I disable fpm from the build, zebra automatically installs the fpm configuration line in zebra.conf (fpm connection ip 0.0.0.0 port 0) at the first write conf. There does not seem to be a way to do a no fpm either from the cli Upon restart 0(backuprouter)# ./zebra -d *** Error reading config: There is no such command. *** Error occured processing line 27, below: fpm connection ip 0.0.0.0 port 0 0(backuprouter)# First off, should I enable fpm on stock FreeBSD ? If I disable it, how do I work around the fpm config issue. Zebra does start up fine, it just complains at startup Secondly, any other tips / suggestions beyond doc/Building_FRR_on_FreeBSD11 ? ---Mike -- ------------------- Mike Tancsa, tel +1 519 651 3400 Sentex Communications, mike@sentex.net Providing Internet services since 1994 www.sentex.net Cambridge, Ontario Canada http://www.tancsa.com/