Donald I figure it out: ip msdp mesh-group <name> member <second ip address of 1st RP> ip msdp mesh-group <name> member <second ip address of 2nd RP> source is for local adress Is there pimd rough draft of manual some where? Or one need to write it from scratch? Is there plan or road map of implementing new msdp commands? On 04/14/2017 02:18 AM, Donald Sharp wrote:
Evgeny -
Apparently we need to update the FRR documentation. Could you open an issue?
In the mean time:
Setup all of the RP's ip addresses to be a loopback device. Add a second /32 ip address to the loopback for MSDP. ( Make sure these are routable )
Create a mesh group of RP's:
ip msdp mesh-group <name> source <second ip address of 1st RP> ip msdp mesh-group <name> source <second ip address of 2nd RP> ....
donald
On Mon, Apr 10, 2017 at 11:21 AM, Evgeny Matuzov <e.matuzov@emzior.ru> wrote:
Hi!
I am trying to test MSDP functionality in virtual environment: FRR <-> cisco, FRR <-> juniper I have not found information about MSDP CLI commands in manual https://frrouting.org/manual/
I would be happy if you can point to some description on how to use MSDP in FRR. Maybe there is new version of manual in development?
Best regards,
Evgeny
_______________________________________________ dev mailing list dev@lists.frrouting.org https://lists.frrouting.org/listinfo/dev