Using https://vincent.bernat.im/en/blog/2017-vxlan-bgp-evpn as a guideline, I was able to get a test environment up and running. I used brctl for local bridging of test and vxlan interfaces. I switched over to openvswitch using ovs-vsctl commands, and was unsuccessful. When running the following, I am missing a "Master (bridge) ifindex __" line. Everything else seems similar, well, other than Type showing up as Ethernet rather than unknown. Is there a bit of secret sauce to run this against openvswitch, or is this not doable at the moment? I havn't poked at the source code to see how the interaction happens. # sh inter vxlan10 Interface vxlan10 is up, line protocol is up Link ups: 0 last: (never) Link downs: 0 last: (never) PTM status: disabled vrf: Default-IP-Routing-Table index 10 metric 0 mtu 1500 speed 0 flags: <UP,BROADCAST,RUNNING,MULTICAST> Type: Ethernet HWaddr: 2e:69:54:74:05:72 inet6 fe80::2c69:54ff:fe74:572/64 Interface Type Vxlan VxLAN Id 10 VTEP IP: 10.10.10.10 Access VLAN Id 1 -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.