Thank you Donald. After I run zebra and fix a few issue in my ip address/route table, things look good. Thanks a lot! Xinwei On Fri, Oct 6, 2017 at 4:28 AM, Donald Sharp <sharpd@cumulusnetworks.com> wrote:
Xinwei -
Those commands are for zebra. Are you running it? I would run zebra and then run bgp and retry.
donald
On Thu, Oct 5, 2017 at 11:38 PM, Xinwei Hong <xhong@skytap.com> wrote:
Thank you Donald. I'm new to FRR. Sorry if my question is dumb. Where do I run the commands? I can telnet to bgpd (port 2605), when I run the commands, it gives me:
bgpd> show ip route
% [BGP] Unknown command: show ip route
bgpd> show int
% [BGP] Unknown command: show int
Note that I only have bgpd running at this moment, zebra is not setup yet.
Thanks, Xinwei
On Thu, Oct 5, 2017 at 2:45 PM, Donald Sharp <sharpd@cumulusnetworks.com
wrote:
Xinwei -
BGP is attempting to validate the nextop given to use and it is failing. What does 'show ip route' and 'show int' give us?
thanks!
donald
On Wed, Oct 4, 2017 at 1:28 PM, Xinwei Hong <xhong@skytap.com> wrote:
Hi
I have a two bgp router setting between 192.168.3.2 and 192.168.3.3.
On
192.168.3.2, I have to following config. similar config as on 192.168.3.3
----bgpd.conf
! -*- bgp -*-
!
hostname bgpd
password zebra
!
router bgp 7632
neighbor 192.168.3.3 remote-as 7633
bgp router-id 192.168.3.2
network 10.200.0.0/16
!
address-family ipv4 unicast
network 10.201.142.0/24
neighbor 192.168.3.3 activate
neighbor 192.168.3.3 next-hop-self
exit-address-family
!
access-list all permit any
!
route-map set-nexthop permit 10
match ip address all
set ip next-hop 192.168.3.3
!
log file /var/log/frr/bgpd.log
log stdout
log syslog
------------------
In log, I find the following errors.
2017/10/03 23:29:40 BGP: 192.168.3.3: nexthop_set failed, resetting connection - intf (nil)
2017/10/03 23:29:40 BGP: bgp_connect_success: bgp_getsockname(): failed for peer 192.168.3.3, fd 9
2017/10/03 23:29:40 BGP: 192.168.3.3 [FSM] Failure handling event TCP_connection_open in state Connect, prior events BGP_Start, BGP_Start, fd 9
Is there anything wrong with my config?
Thanks,
Xinwei
_______________________________________________ frog mailing list frog@lists.frrouting.org https://lists.frrouting.org/listinfo/frog