Hello, I have a lab with frr 7.1 and a bgp l2vpn setting which works fine. I try to install it in production on frr 7.5.1, and it does not work and I cannot see why. It seems the received routes are refused by the destination (both sode have a similar configuration. Here is my configuration : address-family l2vpn evpn neighbor EVPN_UNDERLAY activate neighbor EVPN_UNDERLAY soft-reconfiguration inbound advertise-all-vni autort rfc8365-compatible advertise-default-gw advertise-svi-ip exit-address-family My diagnostics are : # show evpn mac vni 64 Number of MACs (local and remote) known for this VNI: 1 Flags: N=sync-neighs, I=local-inactive, P=peer-active, X=peer-proxy MAC Type Flags Intf/Remote ES/VTEP VLAN Seq #'s f2:47:b9:38:5e:d7 local br64 1 0/0 which is the local mac. On bgp side : # show bgp neighbors xx.xx.xx.202 BGP neighbor is xx.xx.xx.202, remote AS ASn, local AS ASn, internal link Description: ot-cog-rtr-border-1 Hostname: ot-rtr-cog-1 Member of peer-group EVPN_UNDERLAY for session parameters BGP version 4, remote router ID Id2, local router ID Id1 BGP state = Established, up for 00:23:20 Last read 00:00:20, Last write 00:00:20 Hold time is 180, keepalive interval is 60 seconds Neighbor capabilities: 4 Byte AS: advertised and received AddPath: L2VPN EVPN: RX advertised L2VPN EVPN and received Route refresh: advertised and received(old & new) Address Family L2VPN EVPN: advertised and received Hostname Capability: advertised (name: ot-rtr-en1-1,domain name: n/a) received (name: ot-rtr-cog-1,domain name: n/a) Graceful Restart Capability: advertised and received Remote Restart timer is 120 seconds Address families by peer: none Graceful restart information: [...] Message statistics: [...] For address family: L2VPN EVPN EVPN_UNDERLAY peer-group member Update group 11, subgroup 10 Packet Queue length 0 Inbound soft reconfiguration allowed NEXT_HOP is propagated unchanged to this neighbor Community attribute sent to this neighbor(all) advertise-all-vni Inbound path policy configured Outbound path policy configured 0 accepted prefixes [...] And # show bgp l2vpn evpn neighbors xxx.xxx.xxx.202 routes No prefixes displayed, 4 exist On the other side, the advertised-routes show 4 routes (3 type 2 and 1 type 3) I tried to put a route-map with only a permit, but no change. So I'm looking for help in finding the error in my settings Thanks.