If you are receiving `no path to RP address specified` then PIM is receiving your command trying to process it and telling you that it cannotreach the RP. what happens when you issue a `show ip route 10.10.64.1` does it show that you can reach it? donald On Sat, Oct 30, 2021 at 9:06 AM owen s <owen94012@gmail.com> wrote:

Hello everyone

I have read the basic setup of FRR and I would like to setup pim-sm

I edited daemons to enable pimd, here's a list of running processes root 3541 0.0 0.0 12644 4012 ? S<s Oct28 0:03 /usr/lib/frr/watchfrr -d -F traditional zebra pimd staticd frr 3558 0.0 0.2 395068 10136 ? S<sl Oct28 0:02 /usr/lib/frr/zebra -d -F traditional -A 127.0.0.1 -s 90000000 frr 3563 0.0 0.1 15744 6084 ? S<s Oct28 0:00 /usr/lib/frr/pimd -d -F traditional -A 127.0.0.1 frr 3571 0.0 0.1 13524 4548 ? S<s Oct28 0:00 /usr/lib/frr/staticd -d -F traditional -A 127.0.0.1

I am trying to set up pim through the vtysh command but I am not sure that I understand properly using vtysh.

I launch vtysh, then I run configure terminal command, then when I try to run any of the commands from this page: http://docs.frrouting.org/en/latest/pim.html

I keep getting either incomplete command, for example ip pim rp 10.10.64.1 No Path to RP address specified: 10.10.64.1

I have two interfaces, interface eth0 ip address 10.10.60.65/26, it needs to have pim sparse-mode enable on that interface.

How can I configure that using vtysh?

Best, Owen

_______________________________________________ frog mailing list frog@lists.frrouting.org https://lists.frrouting.org/listinfo/frog