[dev] pimd MSDP

[Donald Sharp]

Evgeny -

1) There is no rough draft that has been written.

2) Cumulus has documentation on using pim on our website.  I need to
talk to our doc writers to see if we can figure something out.

3) I am not aware of anyone working on new msdp commands... Whatever
that may mean.

donald

On Tue, Apr 18, 2017 at 4:53 AM, Evgeny Matuzov <e.matuzov at emzior.ru> wrote:
> Donald
>
> I figure it out:
> ip msdp mesh-group <name> member <second ip address of 1st RP>
> ip msdp mesh-group <name> member <second ip address of 2nd RP>
> source is for local adress
>
> Is there pimd rough draft of manual some where?
> Or one need to write it from scratch?
> Is there plan or road map of implementing new msdp commands?
>
>
>
>
> On 04/14/2017 02:18 AM, Donald Sharp wrote:
>>
>> Evgeny -
>>
>> Apparently we need to update the FRR documentation.  Could you open an
>> issue?
>>
>> In the mean time:
>>
>> Setup all of the RP's ip addresses to be a loopback device.  Add a
>> second /32 ip address to the loopback for MSDP. ( Make sure these are
>> routable )
>>
>> Create a mesh group of RP's:
>>
>> ip msdp mesh-group <name> source <second ip address of 1st RP>
>> ip msdp mesh-group <name> source <second ip address of 2nd RP>
>> ....
>>
>> donald
>>
>> On Mon, Apr 10, 2017 at 11:21 AM, Evgeny Matuzov <e.matuzov at emzior.ru>
>> wrote:
>>>
>>> Hi!
>>>
>>> I am trying to test MSDP functionality in virtual environment: FRR <->
>>> cisco, FRR <-> juniper
>>> I have not found information about MSDP CLI commands in manual
>>> https://frrouting.org/manual/
>>>
>>> I would be happy if you can point to some description on how to use MSDP
>>> in
>>> FRR. Maybe there is new version of manual in development?
>>>
>>> Best regards,
>>>
>>> Evgeny
>>>
>>>
>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> dev mailing list
>>> dev at lists.frrouting.org
>>> https://lists.frrouting.org/listinfo/dev
>
>