[FROG] FRR getting started
Heikki Lavaste
heikki.lavaste at hotmail.com
Thu Oct 4 03:48:27 EDT 2018
Hi,
I'm just getting started with FRR in EVE-NG. I have a couple of questions:
1. If I use vtysh to connect, I have access to all routing protocols I have enabled in the daemons file. If I do the same with telnet to localhost 2601, I don't have the protocols. If I understand correctly, I each protocol runs with a different port number and I can connect to OSPF with 2604, etc. Is there a way to "telnet in" and have access to all protocols?
2. Is there a way to get rid of the APIPA kernel routes?
frr(config)# do show ip route
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - OSPF, I - IS-IS, B - BGP, E - EIGRP, N - NHRP,
T - Table, v - VNC, V - VNC-Direct, A - Babel, D - SHARP,
F - PBR,
> - selected route, * - FIB route
B>* 150.1.10.10/32 [20/0] via 155.1.108.10, eth0.108, 00:21:59
E 155.1.58.0/24 [90/0] is directly connected, eth0.58, 00:27:09
C>* 155.1.58.0/24 is directly connected, eth0.58, 00:27:09
E 155.1.108.0/24 [90/0] is directly connected, eth0.108, 00:26:51
C>* 155.1.108.0/24 is directly connected, eth0.108, 00:26:51
K * 169.254.0.0/16 [0/1007] is directly connected, eth0.58, 00:27:48
K * 169.254.0.0/16 [0/1006] is directly connected, eth0.108, 00:27:48
K>* 169.254.0.0/16 [0/1002] is directly connected, eth0, 00:27:48
They are just cosmetic, as long as I don't use the range for any hosts in the lab, but I would like to clean up the routing table.
Knd Regards
Heikki Lavaste
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.frrouting.org/pipermail/frog/attachments/20181004/4cc7f419/attachment.html>
More information about the frog
mailing list