[FROG] setting up frr for pim-sm
Donald Sharp
donaldsharp72 at gmail.com
Sat Oct 30 14:56:11 UTC 2021
If you are receiving `no path to RP address specified` then PIM is
receiving your command trying to process it and telling you that it
cannotreach the RP. what happens when you issue a `show ip route
10.10.64.1` does it show that you can reach it?
donald
On Sat, Oct 30, 2021 at 9:06 AM owen s <owen94012 at gmail.com> wrote:
> Hello everyone
>
> I have read the basic setup of FRR and I would like to setup pim-sm
>
> I edited daemons to enable pimd, here's a list of running processes
> root 3541 0.0 0.0 12644 4012 ? S<s Oct28 0:03
> /usr/lib/frr/watchfrr -d -F traditional zebra pimd staticd
> frr 3558 0.0 0.2 395068 10136 ? S<sl Oct28 0:02
> /usr/lib/frr/zebra -d -F traditional -A 127.0.0.1 -s 90000000
> frr 3563 0.0 0.1 15744 6084 ? S<s Oct28 0:00
> /usr/lib/frr/pimd -d -F traditional -A 127.0.0.1
> frr 3571 0.0 0.1 13524 4548 ? S<s Oct28 0:00
> /usr/lib/frr/staticd -d -F traditional -A 127.0.0.1
>
> I am trying to set up pim through the vtysh command but I am not sure that
> I understand properly using vtysh.
>
> I launch vtysh, then I run configure terminal command, then when I try to
> run any of the commands from this page:
> http://docs.frrouting.org/en/latest/pim.html
>
> I keep getting either incomplete command, for example ip pim rp 10.10.64.1
> No Path to RP address specified: 10.10.64.1
>
> I have two interfaces, interface eth0 ip address 10.10.60.65/26, it needs
> to have pim sparse-mode enable on that interface.
>
> How can I configure that using vtysh?
>
> Best,
> Owen
>
> _______________________________________________
> frog mailing list
> frog at lists.frrouting.org
> https://lists.frrouting.org/listinfo/frog
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.frrouting.org/pipermail/frog/attachments/20211030/3ca21253/attachment.htm>
More information about the frog
mailing list